![]() I learned that I could assign each LDC IC to a specific address by connecting the ADDR pin to either GND or 3.3V. However, after restudying the datasheet again, I realized that this connection could be more simplified. Finally, I connected both LDC ICs to a multiplexer in order to be able to control both LDCs at the same time. Furthermore, I connected a connected an external oscillator to pin CLKIN in order to improve the LDC measurements. In addition, I connected jumpers to pin ADDR in order to make each IC handle more than one address. ![]() Then, I connected SDA and SCL to the head connectors in order to be connected to the 3Dot board. Therefore, I started with design a schematic that contains two LDC sensors which one of them will have two channels and the other one will have one channel only. ![]() UART – Universal Asynchronous Receiver-TransmitterĪfter analyzing the LDC circuit and proving that it works as it was intended, I started to design my LDC PCB front shield.Virtual Reality vs Augmented Reality & Virtual Maze Implementation.Buck/Boost Converter Model with Motor Load.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |